Skip to content

Installation

Installation is very easy

Please follow instructions carefully to ensure a good film fit!

Not following the instructions correctly may result in trapped dirt that will appear as air bubbles under the film. Read the entire instruction set first before attempting to install the film. The film must be fully installed with both masks removed to function properly. Just placing the masked film against the screen will not work.

Installation steps

  1. Your NuShield adhesive film is masked on two sides. One mask covers the top surface and the other mask covers the tacky side.
  2. Make certain that your film fits the display. Lay the film into the display area to be certain that it is sized correctly. A small amount of play or gap on all sides to allow for easy installation is normal. If it does not fit correctly, do not attempt installation and contact us for instructions.
    If the film is larger than the screen and you wish to cut it, use sharp scissors.
  3. Clean the surface of your display with a damp, clean soft cloth. Wipe all areas of the screen, especially the edges and corners. Dry the screen with a soft dry cloth.
  4. Remove the mask covering the tacky side by using a piece of adhesive tape to stick to the mask, pull back and remove this mask completely. You may have to try each side to find the tacky side. Once the back side is exposed, hold the film by the edges and position the exposed tacky side to the screen edge. Allow the film with the exposed back side to attach to the screen.
  5. Allow the exposed back side to adhere to the screen, using a finger to push air bubbles from the center to the edges. Be certain the film is properly aligned to the screen dimensions.
  6. Once you are happy with the installation, remove the mask film covering the top surface. Using a piece of adhesive tape, attach the tape firmly to a corner and lift to remove the top mask. You should now have a fully installed film.

Clean the surface with a wet cloth first and then dry thoroughly

Hold the film by the masked area and place on display

Push out any remaining bubbles for complete fit of the film

No glare.

No germs.

No fingerprints.

No scratches.

Call Now

0800 003 455

Request a quote